Draper FlexShade NEXD 사용 설명서 - 페이지 6

{카테고리_이름} Draper FlexShade NEXD에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper FlexShade NEXD 12 페이지. Clutch-operated small and large hardware
Draper FlexShade NEXD에 대해서도 마찬가지입니다: 설치 및 작동 지침 (6 페이지), 설치 및 운영 지침 (8 페이지), 사용 설명서 (8 페이지), 설치 및 운영 지침 (8 페이지), 설치 및 운영 지침 (10 페이지)

페이지 인쇄

Dual Roller FlexShade

Section 4 - Spring Assist Idler

Caution: Do not allow shade roller to become exposed by running shade fabric too far down. Use stop balls provided in

hardware packet by Draper

to set up and down travel limits. Stop balls by others may be too small, and become lodged

in clutch mechanism.

Remove the safety screw and slide from the top

idler endcap. Retain these pieces for later.

Safety

Screws

(RETAIN FOR

LATER)

Swing the idler end into place, then slide the

idler end spear into the receiver. It may be

necessary to compress the spring-loaded spear.

Figure 5-C

Caution: The retaining clip must be installed around the idler-end

shaft as shown to prevent the roller assembly from moving left or

right during operation, and to ensure that the spring-loaded shaft

does not retract into the mechanism in case of a bearing failure.

NEXD

(Standard Hardware shown)

Figure 5-A

Slide

(RETAIN FOR LATER)

Note: Retainer Clip

has extrusion to ﬁt

into slots on shaft.

Install roller assembly tube

onto clutch.

Tube indentation

must be aligned

with the FLAT side

of the clutch sprocket.

Replace slide and

safety screw.

Place into groove

at an angle, slide

up, and ensure

the bottom of the

slide is hooked into

the receiver.

Figure 5-E

page 6 of 12

Please Note: If shade fabric is

uneven, see "Field Adjustments"

on page 2.

Figure 5-B

Figure 5-D

Use the included

Adjustment Tool

in the

(C202.029)

adjustment point on

the underside of slide

to level shade.