Draper Motorized FlexShade Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wyposażenie wnętrz Draper Motorized FlexShade. Draper Motorized FlexShade 12 stron. Motor operated window shades with several control options
Również dla Draper Motorized FlexShade: Instrukcja instalacji i obsługi (8 strony)

Motorized FlexShade

Section 6 - Fabric/Roller Assembly Alignment

Please note: If needed, the fabric panel heights can be adjusted so that the bottom edges of the fabric panels are aligned. On large units, this procedure should be
done on only one panel at a time to minimize the amount of fabric weight that must be supported during the adjustment procedure. Install and adjust rear/upper
panels before beginning on lower/front panels.
1.
Unlock height adjuster mechanism
at the operator-end of fabric roller assembly that is being adjusted
by rotating the metal ring approximately ¼ turn counterclockwise
(when viewing the face of the coupler assembly)
Please note: Do not use this procedure to adjust the operator-end assembly.
Use the limits to set the down travel of the operator-end assembly.
SPANNER WRENCH DETAIL
Coupler Mounted
to Structure
UNLOCK
LOCK
3.
Rotate the fabric/roller assembly
in either direction to raise or lower
the fabric panel.
7.
Install
next panel.
®
(Coupled)
(or coupler shaft receiver)
.
HEIGHT
ADJUSTMENT
MECHANISM
SPANNER
WRENCH
UNLOCK
4.
Allow the fabric/roller
assembly to move back
and away from the
operator end of the unit,
and check position of
fabric panels.
Finish with
Finish with
Idler Shade Panel.
Idler Shade Panel.
(Steps are shown for endcaps and right-hand operators)
2.
located
Push the fabric/roller assembly approximately 3/16"
(5mm)
fabric/roller assembly will move
approximately 3/16"
the operator end.
5.
Tighten the locking ring by firmly rotating it
approximately ¼ turn clockwise
6.
Operate the unit to check fabric
position, tracking, etc.
Caution: Locking ring on the idler-end coupler assembly
MUST BE fully tightened following height adjustment. Wear a
heavy glove to grip the locking ring. Tighten the locking ring
until it is fully locked and will not rotate any further. Ensure
that it will not loosen. If it cannot be tightened by hand, use a
flat screwdriver or other tool to assist.
toward the operator-end of the unit. The
toward
(5mm)
(reverse of step 1)
LOCK
Begin with
Begin with
Continue with
Continue with
Motor Shade Panel
Motor Shade Panel.
Motor Shade Panel.
Intermediate
Intermediate
Shade Panel.
Shade Panel.
page 8 of 12
.