Electrolux 300 Series Instrukcja obsługi i konserwacji - Strona 41
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Spryskiwacz Electrolux 300 Series. Electrolux 300 Series 46 stron. Front load dryer
Również dla Electrolux 300 Series: Instrukcja obsługi (11 strony), Instrukcja obsługi i konserwacji (39 strony), Instrukcja instalacji (50 strony), Instrukcja obsługi i konserwacji (28 strony)
Drukuj stronę
Common drying inquiries
Many drying problems involve poor cleaning results, poor soil and stain removal, resi-
dues of lint and scum, and fabric damage. For satisfactory drying results, follow these
suggestions provided by The Soap and Detergent Association.
PROBLEM POSSIBLE
CAUSES
Greasy, oily
• Fabric softener
stains
sheet
Lint
• Overloading
• Overdrying
causes static
electricity
• Lint screen not
clean when cycle
began
• Lint is attached
to "pills"
Pilling
• Overdrying
(fibers break
off, ball up
and cling to
fabric)
Shrinking
• Temperature too
high
• Overdrying
Wrinkling
• Overloading
• Leaving items in
dryer after cycle
ends
Isolated wet
• Low water pres-
spots on
sure in home is
fabrics after
not sufficient to
completed
atomize incom-
Steam cycle
ing water during
steam cycle
Troubleshooting
SOLUTIONS
• Rub fabric softener
stains with bar soap.
Rinse and rewash.
• Reduce load size
and rewash using
liquid fabric softener
in the final rinse.
• Or, add a fabric
softener sheet and
tumble without heat.
• Use lint brush or
roller to remove lint.
• Use a lint brush or
shaver to remove
pills.
• Irreversible
condition.
• Reduce load size
and tumble at me-
dium or low heat for
5-10 minutes.
• Remove items im-
mediately. Hang or
fold.
• Check water line
pressure.
PREVENTIVE
MEASURES
• Add a few bath towels
to small loads for proper
tumbling.
• Some "silk-like" fabrics
should be air dried.
• Use proper drying tem-
perature.
• Place fabric softener
sheet on top of load
before starting the dryer.
• DO NOT overload dryer.
• Use fabric softener in
washer or dryer to re-
duce static electricity.
• Remove items when
they are slightly damp to
avoid overdrying.
• Check that lint filter is
clean and in place.
• Use fabric softener to
lubricate fibers.
• When ironing, use spray
starch or fabric finish on
collars and cuffs.
• Turn items inside out to
reduce abrasion.
• Follow fabric care label
directions.
• If shrinking is a concern,
check load often.
• Remove items while
slightly damp and hang
or lay flat to complete
drying.
• Block knits into shape.
• DO NOT overload dryer.
• Remove items as soon
as cycle ends.
• Ensure water line pres-
sure is minimum of 20
psi. DO NOT exceed
120 psi.
41