Electrolux 300 Series Kullanım ve Bakım Kılavuzu - Sayfa 41
Yıkayıcı Electrolux 300 Series için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Electrolux 300 Series 46 sayfaları. Front load dryer
Ayrıca Electrolux 300 Series için: Kullanıcı El Kitabı (11 sayfalar), Kullanım ve Bakım Kılavuzu (39 sayfalar), Kurulum Talimatları Kılavuzu (50 sayfalar), Kullanım ve Bakım Kılavuzu (28 sayfalar)
Sayfayı Yazdır
Common drying inquiries
Many drying problems involve poor cleaning results, poor soil and stain removal, resi-
dues of lint and scum, and fabric damage. For satisfactory drying results, follow these
suggestions provided by The Soap and Detergent Association.
PROBLEM POSSIBLE
CAUSES
Greasy, oily
• Fabric softener
stains
sheet
Lint
• Overloading
• Overdrying
causes static
electricity
• Lint screen not
clean when cycle
began
• Lint is attached
to "pills"
Pilling
• Overdrying
(fibers break
off, ball up
and cling to
fabric)
Shrinking
• Temperature too
high
• Overdrying
Wrinkling
• Overloading
• Leaving items in
dryer after cycle
ends
Isolated wet
• Low water pres-
spots on
sure in home is
fabrics after
not sufficient to
completed
atomize incom-
Steam cycle
ing water during
steam cycle
Troubleshooting
SOLUTIONS
• Rub fabric softener
stains with bar soap.
Rinse and rewash.
• Reduce load size
and rewash using
liquid fabric softener
in the final rinse.
• Or, add a fabric
softener sheet and
tumble without heat.
• Use lint brush or
roller to remove lint.
• Use a lint brush or
shaver to remove
pills.
• Irreversible
condition.
• Reduce load size
and tumble at me-
dium or low heat for
5-10 minutes.
• Remove items im-
mediately. Hang or
fold.
• Check water line
pressure.
PREVENTIVE
MEASURES
• Add a few bath towels
to small loads for proper
tumbling.
• Some "silk-like" fabrics
should be air dried.
• Use proper drying tem-
perature.
• Place fabric softener
sheet on top of load
before starting the dryer.
• DO NOT overload dryer.
• Use fabric softener in
washer or dryer to re-
duce static electricity.
• Remove items when
they are slightly damp to
avoid overdrying.
• Check that lint filter is
clean and in place.
• Use fabric softener to
lubricate fibers.
• When ironing, use spray
starch or fabric finish on
collars and cuffs.
• Turn items inside out to
reduce abrasion.
• Follow fabric care label
directions.
• If shrinking is a concern,
check load often.
• Remove items while
slightly damp and hang
or lay flat to complete
drying.
• Block knits into shape.
• DO NOT overload dryer.
• Remove items as soon
as cycle ends.
• Ensure water line pres-
sure is minimum of 20
psi. DO NOT exceed
120 psi.
41