Electrolux EFLS210TIW Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Spryskiwacz Electrolux EFLS210TIW. Electrolux EFLS210TIW 33 stron. Front load dryer
Również dla Electrolux EFLS210TIW: Instrukcja obsługi i konserwacji (22 strony)

Drukuj stronę

Electrolux EFLS210TIW Instrukcja instalacji

Installation Requirements

Electrical system requirements

CIRCUIT - Individual, properly polarized and grounded 15 amp.

branch circuit fused with 15 amp. time delay fuse or circuit

breaker.

POWER SUPPLY - 2 wire, with ground, 120 volt single phase,

60 Hz, Alternating Current.

NOTE

Because of potentially inconsistent voltage capabilities, the

use of this washer with power created by gas powered

generators, solar powered generators, wind powered

generators or any other generator other than the local utility

company is not recommended.

OUTLET RECEPTACLE - Properly grounded 3-prong receptacle

to be located so the power supply cord is accessible when

the washer is in an installed position.

Grounding type

wall receptacle

Do not, under

any circumstances,

cut, remove,

or bypass the

grounding prong.

Power cord with

3-prong grounded plug

NOTE

GFI (Ground Fault Interrupter) receptacle is not required.

Ground requirements

WARNING

ELECTRICAL SHOCK HAZARD

Improper connection of the equipment grounding conductor

can result in a risk of electrical shock. Check with a licensed

electrician if you are in doubt as to whether the appliance is

properly grounded.

1 The washer MUST be grounded. In the event of

malfunction or breakdown, grounding will reduce the

risk of electrical shock by a path of least resistance for

electrical current.

2 Since your washer is equipped with a power supply

cord having an equipment-grounding conductor and

a grounding plug, the plug MUST be plugged into an

appropriate, copper wired receptacle that is properly

installed and grounded in accordance with all local codes

and ordinances or in the absence of local codes, with the

National Electrical Codes, ANSI/NFPA 70 (latest edition).

If in doubt, call a licensed electrician. DO NOT cut off or

alter the grounding prong on the power supply cord. In

situations where a two-slot receptacle is present, it is

the owner's responsibility to have a licensed electrician

replace it with a properly grounded three prong

grounding type receptacle.

Water supply requirements

Hot and cold water faucets MUST be installed within hose

length of your washer's water inlet. The faucets MUST be

3/4 inch (1.9 cm) with threading for laundry hose connection.

Water pressure MUST be between 10 and 110 psi. Pressure

difference between hot and cold cannot be more than 10 psi.

Your water department can advise you of your water pressure.

Drain system requirements

1 Drain capable of eliminating 6 gals (22.5 L) per minute.

2 A standpipe diameter of 1-1/4 in. (3.18 cm) minimum.

3 The standpipe height above the floor should be:

Minimum height: 24 in. (61 cm)

Maximum height: 56.5 in. (144 cm)

56.5"

(144cm)

max.

24"

(61cm)

min.

Clearance requirements

MINIMUM INSTALLATION CLEARANCES - Inches (cm)

SIDES

Alcove

0" (0 cm)

Under Counter

0" (0 cm)

(0cm)

REAR

TOP

0" (0 cm)*

0" (0 cm)

0" (0 cm)*

0" (0 cm)

(0cm)

FRONT

n/a