Draytek Vigor2952 Series Skrócona instrukcja obsługi - Strona 10
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Firewall Draytek Vigor2952 Series. Draytek Vigor2952 Series 16 stron. Dual-wan security firewall
Również dla Draytek Vigor2952 Series: Skrócona instrukcja obsługi (15 strony)
Drukuj stronę
4
.
H
a
r
d
w
a
4
.
H
a
r
d
w
a
This section will guide you to install the router through hardware connection and
configure the router's settings through web browser.
Before starting to configure the router (taking Vigor2952n for example), you
have to connect your devices correctly.
1.
Connect a cable Modem/DSL Modem/Media Converter (depends on your
requirement) to any WAN port of router with Ethernet cable (RJ-45). Or,
connect the fiber cable to the WAN (SFP) port of router.
2.
Connect one end of an Ethernet cable (RJ-45) to one of the LAN ports of the
router and the other end of the cable (RJ-45) into the Ethernet port on your
computer (that device also can connect to other computers to form a small
area network).
3.
Connect the power cord to the router's power port on the rear panel, and
the other side into a wall outlet.
4.
Power on the device by pressing down the power switch on the rear panel.
5.
The system starts to initiate. After completing the system test, the ACT LED
will light up and start blinking. The WAN1/WAN2/LAN connector LED (Left
or Right) will light up according to the network card feature (1000 or 100) of
the device that it connected.
If Fiber connection is used, check if SFP LED lights up or not.
(For the detailed information of LED status, please refer to section 3. Panel
Explanation)
r
e
I
n
s
t
a
l
l
a
r
e
I
n
s
t
a
l
l
a
t
i
o
n
t
i
o
n
5