ADVANCED FLOORTECH AF-X1 Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Scrubber ADVANCED FLOORTECH AF-X1. ADVANCED FLOORTECH AF-X1 13 stron. Floor scrubber

AF-X1

are basically aligned At this time, press the start button of the brush plate motor on the

control panel, and the brush plate will be automatically installed as the motor rotates. You

can start the operation immediately, or you can install it manually. It is recommended for

unskilled employees to manually install and remove the brush. Disk: Raise the brush

plate first after you finish work. Turn off the brush plate switch, the motor stops rotating

the brush plate by hand, and the brush plate can be removed.

How to replace the battery

①Turn off all pushbutton switches.

②Check the buckle on the battery, disconnect the battery cable, and take out the battery

separately.

Replacement Maintenance Squeegee

The squeegee is an important part of the washing machine. In the daily work process,

the squeegee will be worn due to the friction with the ground. When the water absorption

effect is not good, do the following inspections:

①Is there any foreign matter in the plastic scraper?

②Whether there is any blockage at the connection port of the suction squeegee and the

hose: (remove the joint inspection pipe or remove the suction squeegee to clear the

blockage) Whether the angle between the scraper and the ground is appropriate can be

adjusted by the squeegee universal wheel.

③ Check the wear condition of the rubber strip, if the wear is serious, it should be

replaced in time.

④If the other side is not used, check whether the other side is worn, if it is worn, only

replace the new rubber strip. The normal configuration is the ordinary rubber strip. If you

are using it in a heavily oily environment. Please purchase oil-resistant special tapes.

Work after daily operation