Alemlube O30060 Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pompa wodna Alemlube O30060. Alemlube O30060 17 stron. Oil pump

Drukuj stronę

Safety Warning and Precautions

WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible

conditions or situations that could occur. It must be understood by the operator that common sense

and caution are factors that cannot be built into this product, but must be supplied by the operator.

1. Keep the work area clean and dry. Damp or wet work areas can result in injury.

2. Keep children away from work area. Do not allow children to handle this product.

3. Use the right tool for the job. Do not attempt to force small equipment to do the work of larger industrial equipment.

There are certain applications for which this equipment was designed. It will do the job better and more safely

at the capacity for which it was intended. Do not modify this equipment, and do not use this equipment

for a purpose for which it Was not intended.

4. Check for damaged parts. Before using this product, carefully check that it will operate properly and perform its

intended function. Check for damaged parts and any other conditions that may affect the operation of this product.

Replace damaged or worn parts immediately.

5. Do not overreach. Keep proper footing and balance at all times to prevent tripping, falling, back injury, etc.

6. DO NOT use the equipment when tired or under the influence of drugs, alcohol, or medication.

A moment of inattention while operating this equipment may result in serious personal injury.

Product Specific Safety Precautions

When the pump is connected to the compressed air supply:

1. The compressed air must be filtered to avoid dust and moisture into pump.

2. The maximum compressed air pressure must not exceed 1.0Mpa/150psi.

3. To deliver oil, squeeze the lever on the control valve; delivery stops when the lever is released but the whole system

remains under pressure.

4. Position the control valve so that the circuit can't open accidentally. Otherwise oil could leak onto the ground.

5. Never point the pistol at people or object.

6. Always cut off the air supply after use so that oil can't leak out in case one of the pump's components should break.

7. Use only original spare parts in case the pump has to be repaired or its components have to be replaced.

8. Empty all the oil from the pump in case it has to be disposed of.

9. When not in use, turn off compressed air to stop the pump.

10. Do not use the pump near open flames. Do not smoke during this operation.

11. Wear oil-proof gloves.

12. Do not throw the oil away. Used oil has to be disposed of according to national environmental regulations.

13. The pump can be used only to deliver lubricants, used oil or antifreeze liquids.

Do not use the pump for any other substance.

Read the following precautions and instructions before you begin assembly or using.

Failure to comply with these instructions could result in personal injury or property damage.

Keep these instructions in a convenient location for future reference.

Important Note

The guarantee will be void if the pump has been altered in any way.

NSW/ACT

QLD/PNG

TEL: (02) 9939 0711

TEL: (07) 3889 8480

FAX: (02) 9939 0411

FAX: (07) 3889 8490

OWNER'S TECHNICAL MANUAL

Oil Transfer Kit with Meter & Trolley

VIC/TAS

TEL: (03) 8787 8288

FAX: (03) 8787 8266

Visit our website at

www.alemlube.com.au

SA/NT

TEL: (08) 9209 3066

TEL: (08) 8241 7111

FAX: (08) 9209 3933

FAX: (08) 8241 7011

www.alemlube.co.nz

O30060

TEL: (09) 447 1007

FAX: (09) 447 1008