AND UA-704 Instrukcja obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Monitor ciśnienia krwi AND UA-704. AND UA-704 16 stron.
Również dla AND UA-704: Instrukcja obsługi (16 strony)
Drukuj stronę
6. Press the exhaust valve button to completely
release air from the cuff.
When a measurement is made with insufficient
pressure, the
Re-pressurize the cuff to a pressure. Stop
squeezing the rubber bulb when the
disappears.
When a measurement is made with an erratic
pulse or in a very noisy environment,
be displayed.
7. Turning the power off
Press the
START
The device will be in standby mode.
8. Subsequent measurements
If a subsequent measurement is required, turn off the power and turn it
on again. When "0 " is displayed, the device is ready for another
measurement.
Note: Allow at least three minutes between measurements on the same
person.
9. Automatic power shut-off function
If the device is left on after a measurement, it will turn off
automatically after about one minute.
It may be turned off at any time by pressing the
Notes for Accurate Measurement
Sit down in a comfortable position. Place your arm on a table with your
palm facing upward and the cuff at the same level as your heart.
Relax for about five or ten minutes before taking a measurement. If you
are excited or depressed by emotional stress, the measurement will
reflect this stress as a higher (or lower) than normal blood pressure
reading and the pulse reading will usually be faster than normal.
Your blood pressure varies constantly, depending on what you are
doing and what you have eaten. What you drink can have a very strong
and rapid effect on your blood pressure.
Measurement
mark will be displayed.
button to turn the power off.
English 10
From the previous page
Press the exhaust valve
Bulb
mark
Releasing air
from the cuff
will
START
button.
START
button