AND UA-767PC Instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Monitor ciśnienia krwi AND UA-767PC. AND UA-767PC 17 stron. Digital blood pressure monitor
Preparation for Measurements
1. Installing / Changing the Batteries
Remove the battery cover and insert
new batteries into the battery
compartment as shown, taking care to
observe the proper direction for each
battery. Use R6P, LR6 or similar type
batteries.
If the symbol
are depleted. Always change all batteries at the same time. If you do not
intend to use the device for longer periods, remove the batteries. Only use
high quality, leakproof batteries with the specified ratings. Never mix new and
old batteries or batteries from different manufactures.
Note: Used equipment, parts, batteries do not fall within the category
of household waste, and must be disposed of according to the
applicable regulations.
2. Connecting the Air Hose
Insert the air connector plug into the air socket firmly.
3. Attaching the Arm Cuff
Wrap the cuff around the upper arm
about 2-3 cm (1 inch) above the elbow
as shown. Place the cuff directly against
the skin, as clothing may cause a faint
heart beat, and result in an error.
Constriction of the upper arm caused by
rolling up a shirt sleeve may prevent
accurate readings.
4. Posture While Measuring
Remain seated in a comfortable position,
placing the center of the upper arm at the
same height as your heart.
5. Measurement
During the measurement, the cuff will
become very tight. Do not be alarmed as this is normal.
6. After the Measurement
After the measurement, remove the cuff and record your data.
appears on the display panel, this means that the batteries
2-3 cm (1 inch)
6
Left arm
Hose
Excessive
constriction