formlabs GALVO Czyszczenie - Strona 3

Przeglądaj online lub pobierz pdf Czyszczenie dla Wyposażenie wnętrz formlabs GALVO. formlabs GALVO 7 stron.

3. Remove Galvo Block

Using a 2.5mm hex driver, remove the recessed screws in the upper right

and lower left corners of the galvo block. Once the screws are removed,

slowly wiggle the galvo block free from the Form 1+ frame.

WARNING: DO NOT REMOVE OR TAMPER WITH ANY OTHER SCREWS IN THE

GALVO BLOCK. ADJUSTING ANY OTHER SCREWS WILL MOVE THE PRINTER

OUT OF CALIBRATION.

4. Prepare the Swab

Cut a strip about 1cm wide out of PEC-PAD. Lay the swab stick on the

PEC-PAD as shown above. Apply a piece of tape extending beyond the length

of the PEC-PAD strip.

3/7

DO NOT COPY OR REDISTRIBUTE THIS INFORMATION