Carmanah R247 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt oświetleniowy Carmanah R247. Carmanah R247 15 stron. Solar led roadway light / 24-hour hazard flasher

Drukuj stronę

2.2

Attaching the Mounting Post

Place the Head and Light Mounting bracket onto the post – the cavity in the mounting post

must face traffic. There are five holes in the L-shaped section of the mounting bracket, and

corresponding holes must be drilled into the wood post to a depth of at least 2 inches using a

3/16" drill bit. Ensure the mounting bracket remains in the desired position on the post while

drilling – you may want to temporarily bind it into place using gaffer's tape or similar material.

Once the holes are drilled, fasten the mounting post to the support structure using the supplied

lag bolts and flat washers.

2.3

Mounting the Main Housing Unit

1. Apply some lithium grease to the threads of the Tee pipe.

2. Lift the housing unit above the mounting post and thread the LED harness from the T-

pipe down into the top opening of the mounting bracket.

3. Taking care not to pinch the cable, spin the Main Housing Unit onto the post, threading

the T-pipe into the post collar until one or two threads remain visible on the Tee pipe

(this will allow for final rotational adjustment).

2.4

Mounting the LED Array

1. Hold the support arm and pass the Main Housing Unit LED Harness into the bolt-mount

end of the pipe, shown in Figure 1:

2. Place the flange of the top arm pipe into the mounting bracket and ensure that the

cabling is not pinched – make sure it does not obscure the mounting hole. See Figure

Figure 1

Document number: MAN_ROAD R247 Owner's Manual 37224_vE

Owner's Manual | Model R247

Last revised: November 7, 2006