Andersen 400 Series Regulacja - Strona 3

Przeglądaj online lub pobierz pdf Regulacja dla Wyposażenie wnętrz Andersen 400 Series. Andersen 400 Series 4 stron. Lock mechanism
Również dla Andersen 400 Series: Instrukcja instalacji i demontażu (2 strony), Skrócona instrukcja obsługi (6 strony), Podręcznik zmian (2 strony)

Drukuj stronę

Hinge and Hardware Adjustments

Panel Horizontal Adjustment (Side to Side)

Move all

hinges IN or

OUT to correct

gap and

center panel

in frame.

• Check for equal gap between panel and frame along both sides.

• Starting with the bottom hinge, turn horizontal adjustment screw as shown

to adjust panel as needed. Repeat for remaining hinges working upward.

• Check that gap between panel and frame on latch side and hinge side is

equal to the thickness of the 5/32" hex key.

Panel Vertical Adjustment (Up and Down)

• Check for equal gap between panel and frame at top and bottom.

• Starting with the bottom hinge, turn vertical adjustment screw

clockwise (+) 1/2 turn and then continue turning until panel is

centered vertically in frame.

• Turn next hinge vertical adjustment screw clockwise (+) until panel

moves slightly, then turn counterclockwise (−) 1/4" turn. Repeat for

remaining hinges working upward.

0 0 05 41 3

Equal gap

along both

sides

Equal gap

along top

and bottom

During counterclockwise rotation, stop adjustment

when adjustment screw hits the back side of the cover

and resistance increases. Failure to do so could cause

product damage.

5/32"

Hex Key

Turn counterclockwise

(IN) to move panel

toward hinge side jamb.

Horizontal

Adjustment

Screw

5/32"

Hex Key

Turn counterclockwise

toward (−)

to lower panel

Vertical

Adjustment

Screw

NOTICE

Turn clockwise (OUT)

to move panel away

from hinge side jamb.

Turn clockwise

toward (+)

to raise panel

Bottom

View