Andersen SmoothControl+ Left Hand Hydraulic Closer Instrukcja instalacji - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System otwierania drzwi Andersen SmoothControl+ Left Hand Hydraulic Closer. Andersen SmoothControl+ Left Hand Hydraulic Closer 4 stron. Replacement for andersen 1-1/2” fullview storm doors
Drukuj stronęREMOVE HYDRAULIC
1
CLOSER AND INSTALL
REPLACEMENT PART
(continued)
e
1.
Slide a flat blade screwdriver between the hydraulic closer base plate
and the top of the door frame.
2.
Lift up on the hydraulic closer unit with the screwdriver and slide the
unit sideways toward the hinge side of the door until it is completely
removed. Properly dispose of old hydraulic unit.
g
LOCKING
1.
Pull the closer arm away from door frame
towards the interior until it clears the
hydraulic closer hole, then reinstall the
locking pin into the top of the hydraulic
closer unit.
For Fixed Laminated Glass 3-Point Lock Doors, go to page 4
h
PIN
1.
Partially close the door and pull down
slightly on the closer arm to align the bolt
under the rain cap. Reconnect the hydraulic
closer arm to the rain cap damper assembly
using the provided hex wrench.
Tools recommended:
Hex Wrench
(provided)
Screwdrivers
!
f
5/8"
5/8"
1.
Install the new replacement hydraulic closer unit into the top of
1 1/2"
the door using the reverse process of removing the old unit. When
installing the new unit, ensure the three-prong fork on the mounting
plate is pointing toward the handle side of the door frame. Also, the
middle prong must be positioned below the surface of the door frame
and the two outside prongs above the surface of the door frame.
2.
Install two unpainted flat head screws into the top of the hydraulic
1 1/2"
closer unit. The screws are provided in the clear hardware bag.
3
CLEAR HARDWARE BAG
Unpainted Flat
Head Screws
!
!
5/8"
5/8"
1/2"
1 1/2"
2"
1 1/2"
i
1.
Open door fully and remove the locking
pin from the top of the hydraulic closer
unit.
(Qty 2)
!
1/2"
2"
LOCKING
PIN