- ページ 3

ドア開閉システム Andersen SmoothControl+ Left Hand Hydraulic CloserのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Andersen SmoothControl+ Left Hand Hydraulic Closer 4 ページ。 Replacement for andersen 1-1/2” fullview storm doors

ページを印刷する

REMOVE HYDRAULIC

CLOSER AND INSTALL

REPLACEMENT PART

(continued)

Slide a flat blade screwdriver between the hydraulic closer base plate

and the top of the door frame.

Lift up on the hydraulic closer unit with the screwdriver and slide the

unit sideways toward the hinge side of the door until it is completely

removed. Properly dispose of old hydraulic unit.

LOCKING

Pull the closer arm away from door frame

towards the interior until it clears the

hydraulic closer hole, then reinstall the

locking pin into the top of the hydraulic

closer unit.

For Fixed Laminated Glass 3-Point Lock Doors, go to page 4

Partially close the door and pull down

slightly on the closer arm to align the bolt

under the rain cap. Reconnect the hydraulic

closer arm to the rain cap damper assembly

using the provided hex wrench.

Tools recommended:

Hex Wrench

(provided)

Screwdrivers

5/8"

Install the new replacement hydraulic closer unit into the top of

1 1/2"

the door using the reverse process of removing the old unit. When

installing the new unit, ensure the three-prong fork on the mounting

plate is pointing toward the handle side of the door frame. Also, the

middle prong must be positioned below the surface of the door frame

and the two outside prongs above the surface of the door frame.

Install two unpainted flat head screws into the top of the hydraulic

1 1/2"

closer unit. The screws are provided in the clear hardware bag.

CLEAR HARDWARE BAG

Unpainted Flat

Head Screws

5/8"

1/2"

1 1/2"

Open door fully and remove the locking

pin from the top of the hydraulic closer

unit.

(Qty 2)

1/2"

LOCKING