DREAMVISION T9006000 Montaż i kalibracja - Strona 10
Przeglądaj online lub pobierz pdf Montaż i kalibracja dla Projektor DREAMVISION T9006000. DREAMVISION T9006000 16 stron. Theatre system kit for inti
3.0 PROJECTOR-SIDE CONFIGURATION
3.0 PROJECTOR-SIDE CONFIGURATION
3.1 Configure the projector 12V Trigger output
Connect you THEATER System Kit to the 12V trigger output of the projector
Configure Menu
The "Menu ⇒ ⇒ ⇒ ⇒ Function ⇒ ⇒ ⇒ ⇒ Trigger" menu determines the 12V Trigger output located in the panel input of the Inti 3D
projector this is a global parameter (for all inputs):
You can set the 12V Trigger to:
•
OFF: the 12V Trigger is always OFF.
•
ON (Power): the 12V Trigger is active only when the projector is switched ON.
•
ON (Anamo): the 12V Trigger is active when the projector uses its Anamorphic Mode A, during a 2.35:1 format
projection.
3.2 Configure the Picture Geometry for 2.35:1 Sources.
Apply Anamorphic Mode A function:
When a 2.35:1 source is input and the THEATER System Kit for Inti is mounted, you need to use Anamorphic Mode
A to vertically stretch the picture to obtain a full screen image without distortion.
Browse into the projector menu, and apply the V-stretch function:
Menu ⇒ ⇒ ⇒ ⇒ Installation ⇒ ⇒ ⇒ ⇒ Anamorphic Mode ⇒ ⇒ ⇒ ⇒ Mode A
•
A faster way to operate these changes is to configure a programmable IR-Remote Control or to use RS-232
commands to change Anamorphic Mode applied to the projected image. See "Switching between Formats
with RS-232 or programmable RCU", page 11 for details.
10
The 12V Trigger output indicates when projecting in 2.35:1 format
⇒ ⇒ ⇒ ⇒
⇒ ⇒ ⇒ ⇒
Function
Trigger to "ON (Anamo)"
Anamorphic Kit
R699802 - THEATER System Kit for Inti