DREAMVISION T9006000 조립 및 보정 - 페이지 10

{카테고리_이름} DREAMVISION T9006000에 대한 조립 및 보정을 온라인으로 검색하거나 PDF를 다운로드하세요. DREAMVISION T9006000 16 페이지. Theatre system kit for inti

3.0 PROJECTOR-SIDE CONFIGURATION

3.1 Conﬁgure the projector 12V Trigger output

Conﬁgure Menu

The "Menu ⇒ ⇒ ⇒ ⇒ Function ⇒ ⇒ ⇒ ⇒ Trigger" menu determines the 12V Trigger output located in the panel input of the Inti 3D

projector this is a global parameter (for all inputs):

You can set the 12V Trigger to:

•

OFF: the 12V Trigger is always OFF.

•

ON (Power): the 12V Trigger is active only when the projector is switched ON.

•

ON (Anamo): the 12V Trigger is active when the projector uses its Anamorphic Mode A, during a 2.35:1 format

projection.

3.2 Conﬁgure the Picture Geometry for 2.35:1 Sources.

Apply Anamorphic Mode A function:

When a 2.35:1 source is input and the THEATER System Kit for Inti is mounted, you need to use Anamorphic Mode

A to vertically stretch the picture to obtain a full screen image without distortion.

Browse into the projector menu, and apply the V-stretch function:

Menu ⇒ ⇒ ⇒ ⇒ Installation ⇒ ⇒ ⇒ ⇒ Anamorphic Mode ⇒ ⇒ ⇒ ⇒ Mode A

•

A faster way to operate these changes is to conﬁgure a programmable IR-Remote Control or to use RS-232

commands to change Anamorphic Mode applied to the projected image. See "Switching between Formats

with RS-232 or programmable RCU", page 11 for details.

The 12V Trigger output indicates when projecting in 2.35:1 format

⇒ ⇒ ⇒ ⇒

Function

Trigger to "ON (Anamo)"

Anamorphic Kit

R699802 - THEATER System Kit for Inti