Atlantic Doris mixte Ventilo Standard Instrukcja obsługi i instalacji - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Grzałka Atlantic Doris mixte Ventilo Standard. Atlantic Doris mixte Ventilo Standard 18 stron. Electronic towel-drying heater - electric and combined versions
Drukuj stronę4) Programming
The device can be controlled remotely if its pilot wire is connected to a device fitted with a programmer,
a programming unit or an energy management unit.
Chart indicating the orders the device can receive over its pilot wire
Orders received Current absent
Ref/neutral
oscilloscope
Mode achieved
Heating
temperature
1) Description of the lower part of the device.
A: Switch to control the heating resistor incorpora-
ted in the device.
B: Indicator light to check the operating status of
your device.
C: Supply tap to allow inlet of hot water from the
central heating.This can be thermostatically
controlled or not depending on your choice.
D: Boiler return tap to allow the hot water to leave
the central heating.
E: Lower cover.
Service pressure must not exceed 4 bar.
2) Use on electricity SUMMER SETTING: the central heating circuit is not working.
A switch is on I.The B indicator light is ON, the heating resistor incorporated in the device is supplied.The
supply tap C must be closed. The boiler return tap D must remain open.
3) Use on central heating WINTER SETTING: the central heating circuit is working.
A switch is on O. The B indicator light is OFF, the heating resistor incorporated in the device is not sup-
plied.The supply tap C must be open. The boiler return tap D must remain open.
(to be measured between the pilot wire and the neutral).
CONFORT
CONFORT
setting
U
SING THE DEVICE
CASE OF THE MIXED VERSIONS WITH FAN
Negative half-
Full alternance
alternance
230V
-115V
ECO
STANDBY
3°C to 4°C
Standby
below
temperature,
CONFORT
about 7°C
setting
C
Positive half-
alternance
+115V
STOP LOAD
SHEDDING
Instant device
stop. Can also
be used for load
shedding.
D
E
B
A