Dresser Masoneilan SVI II AP Skrócona instrukcja obsługi - Strona 16

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Sprzęt nagrywający Dresser Masoneilan SVI II AP. Dresser Masoneilan SVI II AP 20 stron. Smart valve interface with remote position sensor

Drukuj stronę

Dresser Masoneilan SVI II AP Skrócona instrukcja obsługi

I I n n s s t t a a l l l l a a t t i i o o n n a a n n d d S S e e t t U U p p

Double Acting Positioner

Output

I I

Connector

F F i i gu

gur r e e 5 5

Air r P P or

Connecting the Air Supply

Connect Output 1, labeled "(

connect Output 2 labeled "(

Figure 5 below for double acting ports.

Figure 5

below for double acting ports.

orts ts o o n n Do

Dou u b b le le Ac

After the tubing is installed, use the following procedure

After the tubing is installed, use the following procedure to connect the

air supply.

1. 1.

Connect a supply of clean, dry compressed air to the filter

Connect a supply of clean, dry

regulator.

2. 2.

Turn on the air supply.

3. 3.

Adjust the filter regulator.

Adjust the

4. 4.

Supply pressure must be 5 - 10 psi greater than the spring

Supply pressure must be 5 -

range of the actuator but may not exceed the rated

range of the actuator but may not exceed

actuator pressure. Refer to

actuator pressure.

instruction manual.

C C o o n n n n e e c c t t i i n n g g t t h h e e T T u u b b i i n n g g a a n n d d A A i i r r S S u u p p p p l l y y

←

I I )" to the inlet port of the actuator and

)" to the inlet port of the actuator and

←

I I I I )" to the opposing actuator port (see

)" to the opposing actuator port (see

Supply

Connector

Acti ting

ng P P os

osi i ti tio o ne

ner r

filter regulator.

Refer to the valve or

9 9

Output

I I I I

Connector

to connect the

compressed air to the filter

10 psi greater than the spring

the rated

the valve or actuator

actuator