Advanced Power WELD 'n' WORK Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Falownik Advanced Power WELD 'n' WORK. Advanced Power WELD 'n' WORK 8 stron.

Drukuj stronę

Important Information

for all owners of

ADVANCED POWER

Engine Driven

Welding Sets

Thank you for purchasing an ADVANCED

POWER Welder Generator. We have

prepared this handbook to make it

easier and safer for you to use and care

for your Welder Generator. Please read

this handbook carefully as it contains

important information which may prevent

serious personal injury or equipment

damage.

Please read this leaflet in conjunction

with the additional engine maintenance

information which can be found in the

accompanying engine owners manual.

Your ADVANCED POWER Welder

Generator has been run, tested and

tuned for optimum performance at the

factory prior to despatch. All petrol and

oil has been drained for safe transport

purposes.

DO NOT START YOUR WELDER-

GENERATOR until you correctly FILL

ENGINE CRANKCASE WITH OIL.

DO NOT ADJUST THE ENGINE SPEED.

ADVANCED POWER GENERATING SETS

HINTS FOR SAFE

OPERATION

AND BEST

PERFORMANCE

n FILL CRANKCASE WITH OIL

as recommended in the engine owner's

manual. Check oil level daily.

DO NOT USE FRICTION MODIFIED OILS.

n USE ONLY FRESH QUALITY FUEL

in your Advanced Power Welder Generator.

DO NOT use fuel that has been stored for

several weeks.

n DO NOT ADJUST OPERATING SPEED.

This has been factory set. Alteration will vary

the output voltage and frequency, which will

cause damage to your appliances and/or

generator and void your warranty.

n ONLY ONE SECTION OF THE SET CAN

BE OPERATED AT ANY ONE TIME.

i.e. Welder or Alternator.

n DO NOT DISCONNECT THE LOW OIL

SENDER LEAD/WIRE. THIS WILL CAUSE

DAMAGE TO YOUR GENERATOR

WELDER AND VOID THE UNITS

WARRANTY

n DO NOT OPERATE YOUR PETROL/

DIESEL DRIVEN WELDER-GENERATOR

AT LESS THAN 1/3 FULL LOAD for long

periods. Light loading can cause glazing

of the cylinder bore , and cause increased

carbon build up in combustion chambers.

After long periods of operation at light

loads, the generator should be operated for

5 minutes at 75% load or more of its rated

capacity to disperse carbon build-up in the

combustion chamber.

OWNER'S GUIDE