Bose SoundLink Wireless Music System Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System stereo Bose SoundLink Wireless Music System. Bose SoundLink Wireless Music System 40 stron. Car charger
Również dla Bose SoundLink Wireless Music System: Instrukcja obsługi (32 strony), Instrukcja obsługi (21 strony), Podręcznik szybkiej konfiguracji (2 strony), Instrukcja obsługi (24 strony), Instrukcja wymiany (2 strony), Instrukcja obsługi (15 strony), Instrukcja obsługi (12 strony), Instrukcja obsługi (24 strony), Instrukcja obsługi (33 strony), Instrukcja obsługi (24 strony), Instrukcja obsługi (22 strony), Instrukcja obsługi (16 strony), Instrukcja obsługi (18 strony), Instrukcja obsługi (24 strony), Skrócona instrukcja obsługi (2 strony), Instrukcja obsługi (22 strony), Skrócona instrukcja obsługi (2 strony), Instrukcja obsługi (16 strony), Instrukcja obsługi (16 strony), Instrukcja wymiany baterii (2 strony), Podręcznik użytkownika (2 strony), Skrócona instrukcja obsługi (2 strony), Instrukcja obsługi (19 strony), Instrukcja obsługi (31 strony), Jak (5 strony), Instrukcja obsługi (2 strony), (Angielski) Podręcznik użytkownika (26 strony), (Japoński) Instrukcja obsługi (3 strony)

Drukuj stronę
Bose SoundLink Wireless Music System Instrukcja obsługi
Note:
•
Where the mains plug or appliance coupler is used as the disconnect device, such disconnect device shall
remain readily operable.
•
The product must be used indoors. It is neither designed nor tested for use outdoors, in recreation vehicles,
or on boats.
•
This product is intended to be used only with the power supply provided.
•
The product label is located on the bottom of the product.
Bose Corporation hereby declares that this product is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC and all other applicable EU directive requirements. The complete
Declaration of Conformity can be found at www.Bose.com/compliance.
Please dispose of used batteries properly, following local regulations. Do not incinerate.

Important Safety Instructions

1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
8. Do not install near any heat sources, such as radiators, heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and
the point where they exit from the apparatus.
10. Use only attachments/accessories specified by the manufacturer.
11. Unplug this apparatus during lightning storms or when unused for long periods of time.
12. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any
way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus,
the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
Information about products that generate electrical noise
U.S.A. only
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, this is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment to an outlet on a different circuit than the one to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
S
I
AFETY
NFORMATION
English – 3