Bose Personalized Amplification System Instrukcja rozwiązywania problemów - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja rozwiązywania problemów dla Wzmacniacz Bose Personalized Amplification System. Bose Personalized Amplification System 50 stron.
Również dla Bose Personalized Amplification System: Instrukcja obsługi (28 strony)
Drukuj stronę
1.2.3 LED Trigger Level
The system has also two signal/clip LED indicators. The signal LED should turn on as soon as
the level reaches -30 dB versus nominal level and the clip LED should light at +6 dB versus
nominal level.
Control Signal
Input
-30 dBV
LED
Remote
-40 dBV
LED
1.3 Auto-detection, Operational Modes and Debug Mode
1.3.1 Rational and Operational Modes
The system can be set up in a variety of different bass configurations. There is some concern,
for example, that a system consisting of a power stand, 2 line arrays and 2 bass modules may
not produce enough bass output for (e.g.) bass players or a kick drum. To this end we have
provided the "Bass Send" output on the power stand that can be connected to the "All Amps In"
input of a second power stand. That second power stand does NOT have any line arrays con-
nected but can drive between 1 and 6 additional bass modules. Figures 7-10 show typical
configurations.
Figure 7. Nominal Bass Configuration, 2 Bass Modules
THEORY OF OPERATION
Clip
Comment
+6 dBV
At Mic/Line PreAmp Output. All levels unbalanced (at internal
measurement points)
-4 dBV
At A/D input. This corresponds to -46 dBFS and -10 dBFS
respectively. There is 10 dB headroom between the clip
indicator coming on and the point where the A/D would
actually clip
Table 3. LED Trigger Levels
Nominal
14