Absima CR6S Instrukcja obsługi - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pilot zdalnego sterowania Absima CR6S. Absima CR6S 17 stron. 2,4ghz radio system

knob for route

setting of

Channel 3

Step 4. >>Tune the knob on the panel which at left down corner for end point of Channel 3 (one side),

setting as 25%/50%/75%/100%, after setting done, cease for 3 second then press CH3 button for

conﬁrm setting, and ﬁnish (indicator light stay on).

If route of Channel 4 need to do setting, no need to press CH3 for conﬁrmation, just go to Step 5

Step 5. >>Tune the knob on the panel which at right down corner for end point of Channel 4 (two side),

setting as 25%/50%/75%/100%, after setting done, cease for 3 second then press CH3 button for

conﬁrm setting and ﬁnish (indicator light stay on).

MODE SWITCH:

Switch to mode (General mode / Mix mode)

Push the trigger forward to the maximum, at the same time, turn the Steering wheel clockwise to the

maximum, hold and power on the transmitter, when indicator light go ﬂashing, pull the trigger backward

to the end, then the indicator light color changes, the trigger should return to the middle position, and the

indicator light is always on to indicate that the mode switch is successful.

(the blue light in General mode is always on, and the red light in Mix mode is always on)

3. Power on, LED go ﬂashing

Mix Mode on:

Under Mix Mode, Connect the two ESC signal lines to the Channel 1 and Channel 2 of the receiver, the trigger

moves backward and forward to control the rotation of the two motors. The positive and negative rotation of

the motor can be set through the two positive and negative switches on the control panel.

Under Mix Mode, the RC model moves forward at a certain speed. At this time, the speed of the two motors

can be adjusted by Channel 1 directional wheel to realize differential steering.

ESC

Under Mix Mode control, the Channel 1 and Channel 2 pass forward and reverse direction, neutral point and

motor route can be set separately.

To switch back to General Mode, go process "Mode switch" once again.

knob for route

setting of

Channel 4

2. Turn wheel

clockwise to the end

and hold

1. Push trigger to the end and hold

ESC

4. Pull trigger to the end.

Relase trigger and LED

change color and stay on

ESC

Receiver

ESC

Channel 3 button

for conﬁrmation