Drucker Diagnostics 614M Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt laboratoryjny Drucker Diagnostics 614M. Drucker Diagnostics 614M 12 stron. 12vdc mobile labaratory centrifuge
Drukuj stronę
Tube Holder Configurations:
The fixed-angle rotor that came with your Model 614M is capable of spinning test tubes
up to 17 mm x 125 mm. Use the following chart and drawing to determine which tube
holder and cushion combination should be used with your application.
DIRECTIONS:
1.
Compare the tube to be spun with the four boxes shown below.
2.
Find the box that most closely matches the tube's length. NOTE: The
tube length with its stopper or cap must be shorter then the chosen
box or the tube will not fit properly in the tube holder.
3.
Match the letter from the chosen box with one of the configurations shown.
A.
For Example: A tube is found to be as long as box B. Accordingly, we can
use a 125 mm tube holder with a 1525 cushion or a 75/100 mm tube holder
with no cushion, (configuration B).
B.
C.
* This part is available as an accessory. Contact Drucker Diagnostics for assistance.
A.
125 mm
Tube
Holder
D.
Page 6
B & C
75/100
mm
Tube
Holder
D.
75/100
mm
Tube
Holder
with
1525
cushion*