DS Services of America 100 Series Podręcznik - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik dla Dozownik wody DS Services of America 100 Series. DS Services of America 100 Series 2 stron. How to clean your water dispenser

Drukuj stronę

Air Filter

SPILL-PROOF

dispenser insert

Separator

Reservoir

Boil a gallon of water and carefully fill the reservoir ¾ full. Let the water sit for 5

minutes (Fig 4).

TIP:

Always use caution when handling hot water. We recommend

boiling partial quantities in a small pot or tea kettle to minimize

risk of spilling while pouring into the reservoir.

Wearing rubber gloves, wipe the inside of the reservoir with a clean cloth or soft

brush. Use caution as the water may still be hot to the touch (Fig 5).

Completely drain the water from the reservoir by dispensing the water through

the hot and cold spigots into a container.

10. Repeat steps 7 and 9 to completely flush the dispenser. It is not necessary to wipe

the inside of the reservoir a second time.

11. Replace the separator and the no-spill dispenser insert. Wipe down the cooler and

the surrounding area to dry any water spills.

12. Wash your hands thoroughly with soap and water for at least 20 seconds. Install

a full water bottle on the dispenser. Plug it in and turn on the hot tank heater

switch located at the rear of the dispenser.

Remove the separator by pulling it straight out.

Make note of the separator positioning before

removing so that it can be re-installed correctly.

Clean these parts with warm, soapy water and let

them dry thoroughly (Fig 3).

Fig 3

hot and cold

Fig 4

Fig 5