Daintree GE Current WFA100-SN Instrukcja instalacji - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Adapter Daintree GE Current WFA100-SN. Daintree GE Current WFA100-SN 11 stron. Wireless fixture adapter

Drukuj stronę

Daintree

Networked Wireless Fixture Adapter (WFA100-SN)

CE Warning message

Sensor (occupancy and photo) wiring lengths above 3m were

not considered for immunity.

FCC Warning Message

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates, uses and radiates radio

frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that

interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment

off and on, the user is encourage to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna;

• Increase the separation between the equipment

and receiver;

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected;

• Consult the dealer or an experienced radio/TV technician

for help.

WFA100

Installation Instructions

Each terminal can accept one conductor only. Connect only

one 24AWG to 16AWG (0.2 -1.5mm2) wire to any terminal

locations showing normal/emergency.

These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation

or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser's purposes, the matter should be

referred to GE Current, a Daintree company.

Input Voltage

Isolated Relay

Load Types

Low Voltage

Output

Analog Dimming

Output

Analog Photosensor 0-10VDC

Input

Analog Input

Digital Input

Radio Properties

Operating

Environment

Compliance

Mounting

Dimensions

* References to "ballast" include LED drivers, general use loads.

WFA100

CAUTION

RISK OF EXPOSURE IF BATTERY IS REPLACED BY AN

INCORRECT TYPE. DISPOSAL OF USED BATTERIES

ACCORDING TO THE INSTRUCTIONS.

Questions:

Web: products.gecurrent.com

Phone: 1-866-855-8629

www.gecurrent.com

General Electric Company and are used under license. Information provided is subject to change without notice.

All values are design or typical values when measured under laboratory conditions.

DT111 (Rev. 04/22/2021

Installation Guide

Specifications

120-277VAC, 50-60Hz

N/O and N/C contacts Load: 3A@120VAC-

-277VAC

Electronic Ballast, General Use

24VDC; 35mA max

22AWG, 600V, UL 1015, plenum rated Max.

recommended length of up to 100' (30m)

Photosensor 0-10VDC

Active high occupancy sensor

2.4 GHz, +8 dBm, Range dependent

on RF propagation variables such

as metal obstacles

Indoor, dry location

-13° to +158°F (-25° to +70°C)

UL, FCC Part 15, CE

Inside fixture, or enclosure

1.18" W x 0.98" H x 7.03" L

(30mm W x 25mm H x 178.5mm L)