3onedata ES1026-2F Instrukcja szybkiej instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja szybkiej instalacji dla Przełącznik 3onedata ES1026-2F. 3onedata ES1026-2F 2 stron. Unmanaged ethernet switch
Drukuj stronę
sufficient size.
Step 2
Adopt screws to install the mounting lugs in the
device position as figure below.
Step 3
Place the device in the rack, adopt 4 screws to
install the mounting lugs on the left and right side in
the rack.
Step 4
Check and confirm the product is firmly installed on
the rack, then mounting ends.
【Rack-mounting Device Disassembling】
Step 1
Power off the device.
Step 2
Unscrew the fixing screw of mounting lug on the
rack.
Step 3
Remove the device from the rack, disassembling
ends.
Attention before power on:
Power ON operation: First insert the power supply
terminal block into the device power supply interface,
and then plug the power supply plug contact and power
on.
Power OFF operation: First unpin the power plug, and
then remove the wiring part of terminal block, please
pay attention to the operation order above.
【Power Supply Connection】
AC power supply
This series of devices provide 4-pin
7.62mm pitch terminal blocks. The pins of
terminal from the left to the right are L, FG,
FG, N. The power supply range: 100~240VAC/DC.
【Checking LED Indicator】
The device provides LED indicators to monitor the device
working
status
with
a
comprehensive
troubleshooting; the function of each LED is described in the
table as below:
LED
Status
Description
Power supply is connected and
ON
running normally
POWER
Power supply is disconnected or
OFF
running abnormally.
The device is powering on or
ON
abnormal
The device isn't powered on or is
RUN
OFF
abnormal
Flash 1 time per second, the device
Blinking
is running normally.
ON
Ethernet port connection is active.
Link/Act
Ethernet port is in network active
Blinking
(1-26)
status
OFF
Ethernet port connection is inactive
【Specification】
Panel
100M copper port
10/100Base-T(X),
automatic flow control, half/full
duplex
MDI/MDI-X self-adaption
100M fiber port
100Base-FX,
SC/ST/FC interface
Indicator
Power
indicator, interface indicator
Exchange Attributes
Backplane bandwidth
12.8G
Packet buffer size
MAC table size
Power supply
Input power supply
Access terminal
Consumption
No-load
and
simplified
Full-load
Environmental Limits
Working temperature
Storage temperature
Working humidity
Protection grade
RJ45
port,
self-adaption,
optional
supply indicator,
run
2.5Mbit
8K
100~240VAC/DC
4-pin 7.62mm pitch terminal
blocks
4.2W@220VAC
6.7W@220VAC
0~70℃
-40~75℃
5%~95% (no condensation)
IP30 (metal shell)