Attero Tech CommandHub Podręcznik użytkownika - Strona 7
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt sieciowy Attero Tech CommandHub. Attero Tech CommandHub 20 stron. Unify proxy device for control and routing
Drukuj stronęCommandHub
User Manual
2.2 – Network Connections
In order to operate, the CommandHub requires that the control network and the Dante network are completely separate.
The CommandHub acts as a bridge between them passing only control system packets meant for audio device control to
the audio network and returning any subsequent responses.
Figure 2 - CommandHub Application Diagram
*Note: The CommandHub can't be used if the control system uses the same network as the Dante network as it does not
support this mode of operation. The control network must be separate network with a different set of IP addresses to the
Dante network.
There are several advantages to this approach the most obvious being regarding the use of wireless devices for control.
Dante itself does not support the use of WiFi and wireless devices. With a separate control network, WiFi and wireless
devices can be used which in turn allows devices tablets and smart phones can be used as control surfaces. This would
not be possible with a single combined Dante and control network.
*Note: The Dante network and Control network must be separate physical networks each using a different address range.
However, this does not mean there needs to be separate infrastructure and the two networks can reside on the same
switch providing the necessary VLAN's have been set up.
© Attero Tech LLC 2015
Page 6
614-00019-01