Boulevard DVP36LPKR-1 Instrukcja instalacji
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria do kominków Boulevard DVP36LPKR-1. Boulevard DVP36LPKR-1 8 stron. Porcelain panel kit
Drukuj stronęFOR USE ON: DVLL(36,48)BP SERIES FIREPLACES ONLY
INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION.
DVP36LPKR-1 Porcelain Panel Kit
CARTON CONTENTS:
•
Rear Porcelain Panel
•
Left Side Porcelain Panel
•
Right Side Porcelain Panel
•
Screw Package
•
Side Retainer Bracket
(Qty. 2)
PREPARATION
Sharp edges! To avoid injury, wear safety gloves to
install liner.
1. Refer to the fireplace installation manual for removal
of the Barrier and Glass Door assemblies prior to
installation of the porcelain liner kit.
2. Remove decorative media from hearth and burner cover.
3. Carefully unpack the porcelain liners, verify that all
components are included, and inspect for hidden
damage, prior to installation.
4. Remove the front Light Cover by lifting it up and out,
then set it aside.
5. If installed, remove painted liners from the fireplace.
Remove the screw retaining the right side panel with
a 5/16" nut drive, and remove the panel. Repeat the
process for the left side panel. See Figure 5 for screw
location.
6. Remove the two screws that retain the rear liner panel
and then remove the panel. See Figure 3 for screw
locations.
36468-2-0220
INSTALLATION INSTRUCTIONS
DVLL(36,48)BP SERIES FIREPLACE KITS
TOOLS NEEDED:
•
Gloves
•
Eye Protection
•
5/16" Hex Driver
CAUTION
Empire Comfort Systems Inc. • Belleville, IL
DVP48LKR-1 Porcelain Panel Kit
INSTALLATION
1. Check the Rear Liner Panel to make sure it is not
bowed. NOTE: The bottom edge has eight tabs that
must be in a straight line to match up with the slots
at the rear of the firebox. Check to make sure the
insulation on the back of the panel remains in place
before installation.
2. Install the Rear Panel by aligning the eight tabs on the
bottom edge with the eight slots in the back rear of the
firebox. NOTE: The eight slots are located behind the
burner cover plate. See Figure 1.
S L O T S
T A B S
Figure 1
Page 1