DAN NTP TECHNOLOGY DAD Thunder Core 256 Instrukcja instalacji - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt nagrywający DAN NTP TECHNOLOGY DAD Thunder Core 256. DAN NTP TECHNOLOGY DAD Thunder Core 256 16 stron. Thunderbolt 3, dante, madi and adat digital audio interface

Installation Guide Core 256
he selection of either of the two recovery modes are fixed after selection. The AX64 will start with a basic boot
software and IP configuration. The AX64 will not be operational until a proper firmware has been downloaded
via the DADman software and it has been restarted. By enabling recovery mode with default IP address and
network configuration the unit can always be identified on a network via the default setup.
Note that the IP address referred to is the IP address of the controller/management interface of the
unit. This is not the IP address of the IP audio interface if a such is installed. This IP address cannot
be accessed in recovery or restore defaults mode.

Specifications

Digital I/O formats/ Supported sample rate
Synchronisation
Interfaces
Interfaces
Interfaces
Latency
Channels and Sample rates per link
Doc no. AXCNTR-8001-A-4
and Green LED is
network, the AX64 will default to IP address
on
10.0.7.20 / 255.255.0.0 after approx. 2 minutes.
Green LED
turns OFF
"
Digital I/O and Synchronisation
Dante™ IP audio and ADAT/SMUX up to 192 kHz
Thunderbolt 3 and MADI up to 384 kHz
DADLink up to 384 kHz
Word Clock, Video Blac Burst, Dante, ADAT and MADI
Network Interface
1000BASE-T, RJ45 connector, 4-pair connection
Thunderbolt 3 Interface
2 x USB-C type connectors, supporting link functionality
and 15w power on each port.
DADLink Interface
2 x SFP connectors for Gigabit SFP modules for multi-
mode LC optical fibre connection.
Below 1 microsecond latency between interconnected
units. The overall latency is defined by the system delay
set for all the units which is normally 7 samples. All I/O
connections across units are 100% aligned in phase.
128 channels
64 channels
32 channels
16 channels
Double channel count by using two fibre links.
Rev. date 201123
@44.1 and 48 kHz
@88.2 and 96 kHz
@176.4 and 192 kHz
@352.8 and 384 kHz
Page 15 of 16