DAN DRYER 288 Podręcznik użytkownika - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Suszarka DAN DRYER 288. DAN DRYER 288 6 stron. Stainless design turbo hand dryer

Drukuj stronę

PRODUCT APPLICATION

• Shake excess water from hands

• Place hands under the dryer to turn it on

• Rub hands lightly and rapidly

• Stops automatically after hands are removed.

RECOMMENDED INSTALLATION HEIGHT

From bottom edge of hand dryer above finished floor.

Men

1270 mm

(50")

Women

1194 mm

(47")

Children 4-7 years

889 mm

(35")

Children 8-10 years

991 mm

(39")

Children 11-13 years

1092 mm

(43")

Children 14-16 years

1194 mm

(47")

Wheelchair users

1016 mm

(40")

CLEANING AND MAINTENANCE

Routine cleaning and maintenance is recommended every 12 months.

• Cut the power

• Unscrew (2) bottom security screws

• Remove the cover

• Clean the cabinet inside and remove dust/dirt. You can use compressed air

• Check carbon brushes in the motor. If carbon brushes are worn (≤ 10 mm graphite

remaining), they must be replaced

• Clean sensor lense on both sides

• Do not rinse with running water

• Use a damp cloth and mild cleaning solution. Never use cleaning detergents with an

abrasive effect

• Replace cabinet front and tighten screws. Be careful not to overtighten screws

ADJUSTMENT OF AIR SPEED AND TEMPERATURE

• Insert Philips screwdriver or flat notch through the hole at the bottom of the cover and

place the screw head on the potentiometer screw (see drawing below)

• Adjust air speed and temperature on the VR potentiometer:

Clockwise to increase air speed and temperature (+)

Counterclockwise to decease air speed and temperature (-)

• Be careful not to overturn the adjustment screw

ADJUSTMENT OF SENSOR RANGE

The sensor range is adjsutable between 100 mm and 230 mm. Standard range 170 mm

± 20 mm.

• Switch off power and dismount the cover by loosening (2) screws at the bottom

• Use a small Philips screwdriver or similar to adjust the sensor on the VR screw:

Clockwise to increase sensor activation range (+)

Counterclockwise to decrease sensor activation range (-)

• The sensor activation range should be adjusted to its environments, e.g. light and

distance to the bottom of the sink

• Be careful not to overturn the sensivity adjustment