AnyTone ARES II Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Radio AnyTone ARES II. AnyTone ARES II 16 stron.
Również dla AnyTone ARES II: Instrukcja obsługi (16 strony)

AnyTone ARES II Instrukcja obsługi
1. Connect the positive (red) power cable to the + terminal of the battery.
2. Connect the negative (black) power cable to the - terminal of the battery.
3. Connect the DC power cable to the transceiver's power supply connector.
▲ Locate the power cable away from high temperature, moisture, and other
electrical systems. Ensure it is installed where it cannot be damaged.
▲ It is not recommended to use a vehicle cigar/cigarette lighter socket to power the
radio, as it may not supply the correct voltage or current.
▲ Do not remove the fuse holder from the cable.
+ (Red wire)
REPLACING FUSES
This radio requires a 10A, 250V fuse.
If the fuse blows, determine the reason, then correct the problem.
After the problem is resolved, replace the fuse. If newly installed fuses continue
to blow, disconnect the power cable and contact your authorized dealer or an
authorized service center.
1. Twist the two fuse covers in opposite directions, and open it.
2. Replace the blown fuse with new one, and close the fuse holder.
3. Be sure to only use the correct fuse type, otherwise damage may
occur.
IN-LINE
FUSE HOLDER
10A 250V FUSE
IN-LINE
FUSE HOLDER
- (Black wire) connected to
chassis ground in most 12V
vehicles (confirm with your
vehicle manufacturer)
,
IN-LINE
FUSE HOLDER
IN-LINE
FUSE
FUSE HOLDER
4