- ページ 8

ラジオ AnyTone ARES IIのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AnyTone ARES II 16 ページ。
AnyTone ARES II にも：取扱説明書 (16 ページ)

1. Connect the positive (red) power cable to the + terminal of the battery.

2. Connect the negative (black) power cable to the - terminal of the battery.

3. Connect the DC power cable to the transceiver's power supply connector.

▲ Locate the power cable away from high temperature, moisture, and other

electrical systems. Ensure it is installed where it cannot be damaged.

▲ It is not recommended to use a vehicle cigar/cigarette lighter socket to power the

radio, as it may not supply the correct voltage or current.

▲ Do not remove the fuse holder from the cable.

+ (Red wire)

REPLACING FUSES

This radio requires a 10A, 250V fuse.

If the fuse blows, determine the reason, then correct the problem.

After the problem is resolved, replace the fuse. If newly installed fuses continue

to blow, disconnect the power cable and contact your authorized dealer or an

authorized service center.

1. Twist the two fuse covers in opposite directions, and open it.

2. Replace the blown fuse with new one, and close the fuse holder.

3. Be sure to only use the correct fuse type, otherwise damage may

occur.

IN-LINE

FUSE HOLDER

10A 250V FUSE

IN-LINE

FUSE HOLDER

- (Black wire) connected to

chassis ground in most 12V

vehicles (confirm with your

vehicle manufacturer)

IN-LINE

FUSE HOLDER

IN-LINE

FUSE

FUSE HOLDER