DuctSox SkeleCore Pull-Tight Cable Instrukcja instalacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Urządzenia przemysłowe DuctSox SkeleCore Pull-Tight Cable. DuctSox SkeleCore Pull-Tight Cable 16 stron.

Drukuj stronę

SkeleCore Pull-Tight Cable

STEP 4

Install Tensioning Baskets and Fabric. Tensioned Sections must be completed in succession moving away from the Inlet Belt.

Overview of Step 4:

A. Install fabric Inlet Belt onto metal collar

B. Install Tensioning Basket

C. Using Project-Specific Drawing, install the balance of Tensioning Baskets and fabric.

D. Tension fabric

E. Fitting considerations

A. Install fabric Inlet Belt onto metal collar.

DuctSox Inlet must be attached to the metal collar using screws (not included) through

plastic patches on the Inlet Belt. Be sure to locate the zipper start and seam at the

12:00 orientation for proper alignment.

B. Install first section of DuctSox fabric and Tensioning Basket at Inlet Belt.

Rivet the UR Connector to the Universal Ring. This assembly may already be

completed for you by DuctSox factory.

Rivet the Tension Cable Lock to 12:00 of the Universal Ring (2x). Each one in opposite

directions.

NOTE: When the Tensioning Basket is assembled, the UR Connectors point

towards each other. The Tension Cable Lock Levers point in the same direction

towards the fabric section being tensioned (see drawing on page 8 for

clarification).

WARNING: If this is done incorrectly, the system WILL NOT TENSION.

Install the Universal Ring assembly on the cable (2x). (Through the fabric and zipper

where required.) The lever of the Cable Lock will point towards the section being

tensioned.

Finish the basket by connecting the two Universal Ring assemblies with the basket tube.

Install Universal Ring Assembly on Cable

Installation Manual

Top zipper, open

Inlet Patch

Tension Cable Lock Levers

UR Connectors

Finish Basket with UR Connector

Publication: AMEN00417 2021-02-22

DuctSox