anytronics Anyscene 1 Instrukcja instalacji i obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Kontroler anytronics Anyscene 1. anytronics Anyscene 1 6 stron. Memory unit

1. Overview and Operation

The Anyscene 1 memory unit provides seven programmable DMX scenes of 36 channels,

plus a 'Blackout' function in a double pattress housing suitable for use in architectural

applications. Only a single Anyscene 1 can be used within an installation and if control at

multiple locations is required the installer should use the Anyscene 512 range.

The front panel has ten buttons and ten LED indicators. Switches labelled 1-7 have their

own blue mimic LEDs and are used for storing and recalling the contents of the 7

programmable memories.

The Up and Down buttons are normally used to control the Master level, allowing control

of the overall lighting level.

The green power LED shows when the unit is powered up, and the yellow data LED

indicates that the unit is receiving suitable data from a DMX source for programming or

the unit has gone into standby mode allowing external control. Switch 0 is the blackout

switch and when enabled the corresponding red LED will flash to indicate the unit is in this

mode.

The RJ45 sockets are on the back of the PCB along various option DIL switches and the

connectors for the external scene recall control.

The Anyscene 1 should be mounted using UK double pattresses with an approximate

depth of 32 mm.

Units 5 & 6 Hillside Industrial Estate

London Road, Horndean,

Hampshire, PO8 0BL

Tel +44 (0)23 9259 9410

Fax +44(0)23 9259 8723

Page 2 of 6

AT1042 Issue 1

Anyscene 1 Operating

Instructions