Anywave TRN U2D Skrócona instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Nadajnik Anywave TRN U2D. Anywave TRN U2D 16 stron.

3 TX System Overview

Final assembly and test of each transmitter are performed at the Anywave factory.

The Exciter is set up on the desired channel frequency and the TX is tested with the

complete RF system (if purchased) at full power into a load. All TX operating

parameters are optimized and the Transmitter Forward and Reflected power meters are

properly calibrated. Linear and Nonlinear precorrection is performed and automatically

stored in non-volatile memory inside the Exciter. A Factory Test Report is completed

for each system, providing a record of full power operating parameters and performance.

The TX then goes through a final 24-hour burn-in period and check out before being

shut done and packed up for shipment.

In your shipment, you should receive a copy of the following documentation.

- Packing Checklist

- Transmitter Factory Test Report

- ACT TRN-U2D-C-FA Quick Start Guide

- ACT PA-U2D-C-FA PA User Manuals

Carefully unpack and inspect all your equipment and please review the Packing

Checklist when you receive your system to be certain you have received all your system

components. Also, please be sure to identify and remove all packing materials and

supports (foam pads, etc.) prior to initial turn-on of the equipment.

All Single PA TX systems ship with an AC power cord included with the Exciter

and PA. The PA shipment also includes an RS232 cable and an RS232-to-485 adapter,

for Exciter to PA communications, and a CAT5 Ethernet cable, for Exciter to PC built-

in web interface Remote Monitoring and Control.

ACT-PA-U2D-QSG-DOC-V2.2, 09/25/2019

TRN-U2D-C-FA Quick Start Guide

Page 7 of 16