Anywave TRN U2D Hızlı Başlangıç Kılavuzu - Sayfa 7

Verici Anywave TRN U2D için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Anywave TRN U2D 16 sayfaları.

3 TX System Overview

Final assembly and test of each transmitter are performed at the Anywave factory.

The Exciter is set up on the desired channel frequency and the TX is tested with the

complete RF system (if purchased) at full power into a load. All TX operating

parameters are optimized and the Transmitter Forward and Reflected power meters are

properly calibrated. Linear and Nonlinear precorrection is performed and automatically

stored in non-volatile memory inside the Exciter. A Factory Test Report is completed

for each system, providing a record of full power operating parameters and performance.

The TX then goes through a final 24-hour burn-in period and check out before being

shut done and packed up for shipment.

In your shipment, you should receive a copy of the following documentation.

- Packing Checklist

- Transmitter Factory Test Report

- ACT TRN-U2D-C-FA Quick Start Guide

- ACT PA-U2D-C-FA PA User Manuals

Carefully unpack and inspect all your equipment and please review the Packing

Checklist when you receive your system to be certain you have received all your system

components. Also, please be sure to identify and remove all packing materials and

supports (foam pads, etc.) prior to initial turn-on of the equipment.

All Single PA TX systems ship with an AC power cord included with the Exciter

and PA. The PA shipment also includes an RS232 cable and an RS232-to-485 adapter,

for Exciter to PA communications, and a CAT5 Ethernet cable, for Exciter to PC built-

in web interface Remote Monitoring and Control.

ACT-PA-U2D-QSG-DOC-V2.2, 09/25/2019

TRN-U2D-C-FA Quick Start Guide

Page 7 of 16