Anzzi L-AZ 905 Series Instrukcja instalacji i obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Produkt hydrauliczny Anzzi L-AZ 905 Series. Anzzi L-AZ 905 Series 8 stron. 2 tone lavatory faucet

Drukuj stronę

INSTALLATION

1
Rod
[11]
[13]
[14]
[15]
STEP 1:
1.
Remove Rubber Gasket [13], Metal Gasket [14] and Lock Nut [15] from Spout [01].
Install Hoses [16] to the screw holes at the bottom of the Spout [01] and tighten the Hoses [16] to
2.
secure.
3.
Slide Hoses [16] through O-Ring [08], then install Spout [01] with O-Ring [08] in faucet hole. Adjust the Spout
[01].
4.
Slide Rubber Gasket [13] and Metal Gasket [14] up onto the Rod of Spout [01] under sink and secure
with Nut [15]. Start by hand tightening the Nut [15] first and finish tightening with T-Wrench [18] to secure.
STEP 2:
1.
Slide the Valve Assembly [09] with Rubber Washer [10], Metal Washer [11] and Lock Nut [12] up
through the faucet hole from underneath the sink.
Note: The Valve Assembly [09] with red ring should be installed on the left. The other on the right.
2.
Place the O-Ring [08] over the Valve Assembly [09] on top of the sink, then install the Handle Base [07]
to the Valve Assembly [09] over the O-Ring [08]. Tighten the Handle Base [07] to secure.
3.
Adjust each Valve Assembly [09] so its outlet is pointing at the Spout [01]. Then install the Handle [06]
to the stem of the Valve Assembly [09].
4.
Turn the left Handle [06] clockwise and the right Handle [06] counter-clockwise until they stop. If the
Handle [06] doesn't align with the Handle Base [07] properly, pull up the Handle [06], turn it to the
correct position and install Handle [06] again. If the Handle [06] is still misaligned, unscrew the Handle
Base [07] a little bit to align with the Handle [06].
5.
Make sure the left Handle [06] can't be turned in clockwise and the right Handle [06] can't be turned in
counter-clockwise again. Then, adjust the Valve Assembly [09] so that the Handles [06] are level and
the outlets point to the Spout [01]. Hand tighten the Lock Nuts [12] and tighten the screws with a
screwdriver to secure. Turn the Handles [06] to make sure they move smoothly.
6.
Secure the Handles [06] by tightening Screws [04] with Allen Key [17] and cover Screws [04] with
Buttons [03].
PG.3
2
[01]
[16]
[08]
[06]
Stem
red ring
outlet
[04]
[17]
[03]
[07]
[08]
[01]
[09]
[10]
[11]
[12]
blue ring