Anzzi SD-AZ8076-01 Series Instrukcja instalacji i obsługi - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Produkt hydrauliczny Anzzi SD-AZ8076-01 Series. Anzzi SD-AZ8076-01 Series 16 stron. Glass shower door
4
1.
Loosenthe screwsat the back of the Clamp until it isn't protruding fromthe side of
groove and push it into the Fixed Panel [01] until it stops. Adjust the Support Bar [02]
until the Fixed Seat touches the wall surface and the angle formed by the wall and the
Support Bar [02] is about 45°. Make sure there is a Gasket between the Clamp and
Fixed Panel [01]. (Fig 4.1,Fig 4.2)
2.
Secure the Clamp by tightening the screws .(Fig 4.2)
3.
Gently push the Fixed Seat onto the wall and mark the outline of the Fixed Seat on the
wall.(Fig 4.3)
4.
Remove the Screw connecting the Bar and the Fixed Seat and move the Bar away .(Fig 4.3)
5.
Place the Fixed Seat on the marked position and mark the screw hole on the wall. (Fig 4.4)
6.
Move the Fixed Seat and drill a 5/16" hole on the marked location. (Fig 4.5)
7.
Insert the Plastic Anchor into the wall. (Fig 4.6)
8.
Secure the Fixed Seat with a Screw [04]. (Fig 4.7)
9.
Secure the Bar to the Fixed Seat with the Screw. Tighten the Screw to secure. (Fig 4.8)
10.
Tighten the other Screw of the Support Bar [02]. (Fig 4.9)
Screw
10
[04]
Screw
Screw
4