Danco GoBidet 2003 Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Narzędzia Danco GoBidet 2003. Danco GoBidet 2003 6 stron.

INSTALLATION INSTRUCTIONS - IMPORTANT NOTES

his unit can accommodate hot and/or cold water installations.

For cold water only, it can be installed as purchased. Hot water

installation kits (Part no. 2003HIK) are available by calling

1.888.GoBidet.

Your GoBidet™ will attach to a one-piece (tank and bowl are

molded into one piece) or two-piece (tank and bowl are separate)

toilet and a regular (round) or elongated toilet. See "Parts break-

down" page for instructions on changing the bushing bracket mounting

location.

Use Teflon tape (provided) in all connections.

A. DISCONNECTING YOUR TOILET'S WATER SUPPLY LINE

1. Turn off water supply to toilet. It is usually an angle-stop/cut-off

valve on wall beneath toilet.

2. Empty toilet completely by holding flush handle down.

3. Put a shallow basin beneath water shut-off valve (at wall) and

water line connection at tank to catch excess water.

4. Disconnect water line from cut-off valve at wall and tank.

5. Clean and dry fittings and threads of tank and cut-off valve.

B. INSTALLATION INSTRUCTIONS

1. Remove toilet seat and clean mounting area.¹ Save seat

mounting parts to re-use.

2. After applying Teflon tape to its threads, attach braided "T" hose

(Part no. 2003.3W) to GoBidet™ housing by screwing male fitting

of "T" hose into inlet marked with a "C" in back of GoBidet™.

Tighten.

3. Determine if your toilet is a one-piece or two-piece unit. If you

have a one-piece unit please follow instructions on changing

bushing bracket (2003.09) mounting location (see center fold

page).

4. Insert threaded bushing of support bracket (Part no 2003.09) into

toilet bowl screw opening used for mounting toilet seat. Use

opening on your left when facing the toilet tank. Secure to toilet by

installing rubber washer first, followed by plastic washer and

chrome nut onto bottom of threaded bushing. Finger tighten only.

Before tightening bushing completely, move shower arm (Part no.

2003.01) to its maximum extension, moving the support bracket

(Part no. 2003.09) until shower head is in center of toilet. Upon

retraction, shower arm should rest beneath rim of toilet. Finish

tightening bracket in place. DO NOT OVER-TIGHTEN BUSHING

OR TOILET WILL CRACK.