Addictive Desert Designs ADD-Lander Skrócona instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Akcesoria samochodowe Addictive Desert Designs ADD-Lander. Addictive Desert Designs ADD-Lander 5 stron. 2005-current toyota tacoma overland rack
Również dla Addictive Desert Designs ADD-Lander: Instrukcja instalacji (6 strony)
Drukuj stronęADDICTIVE DESERT DESIGNS® ®
ADDICTIVE DESERT DESIGNS
Installation:
3. Slide the supplied Square Nuts (6 per side) into the rail system in the bed of the Jeep. Make sure to line them
up about where the mounting holes of the chase rack are going to land. (Fig C)
Fig C
Fig C
4. Install the supplied 1/2" x 1" Bolts (6 per side) and 1/2" Washers (6 per side) into the side rail. If the 1" long
bolts don't reach, you will have to use the start 1 1/2" long bolt into one of the holes to bring the chase rack rail
closer to the truck bed rail. Once the chase rack is close enough to the bed rail, start the 1" bolt in the hole right
next to the one you've started the 1 1/2" long bolt in. Then, remove the 1 1/2" long bolt and reinstall the 1" long
bolt. Do not tighten the 1 1/2" long bolt all the way (it will hit the back of the bed rail), only use it to bring
the chase rack closer to the bed rail. Leave these bolts loose for now. (Fig D)
Fig D
Fig D
Addictive Desert Designs® | Page 3
2020-Current Jeep Gladiator JT ADD-Lander™
Overland Rack Installation Instructions