Abtus AVS-1200C/V2 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kontroler Abtus AVS-1200C/V2. Abtus AVS-1200C/V2 8 stron. Multimedia controller

Drukuj stronę
User Operation Guide
PROGRAMMING MODE
“Delay Time”
“Delay Time” setup allows setting of delay time between switching function of projector.
Example: Projector ON “Warm up time”, Projector Off “Cool down time” and “Projector Input
Switching interval time”
All above timing defer from Brand and model of different Projector.
“On” and “Off” delay time range can set from 5 to 240 sec.
“Other” as in the switching delay timing is from 1 to 5 sec.
“Auto Repeat”
“Auto Repeat” function allow projector “Power ON” and “Power OFF” command to be send
twice automatically with a delay time. This may be required base on different brand and model
of projector.
“Volume”
“Volume setup allows configuration of the volume setting for AV-Switcher or Projector.
Initial Volume set is the default volume setting for every Power ON.
2.0 Under “File” Tab
New
- Opening a NEW project
Open
- Open of program
Save
- Save a Project
Save as
- Save a Project under different name and location
Exit
- Exit of Multi Media Control Program
PROGRAMMING MODE
2.1 Opening a program file
2.3 Under “Com port” Tab
Setting of serial parameter of the PC configuration/communication between the PC and
Device “Controller AVS-1200CV2”
Com Port Setting:
Control Program’s RS232 communication port select.
Select range: COM1~ COM6.
Note:
Control Program’s RS232 communication protocol
default setup are as followed:
Baud Rate: 9600 bps.
Data length: 8 bits.
Parity: Non parity.
Stop bit: One bit.