AudioCodes GW & E-SBC Series Uwaga dotycząca konfiguracji - Strona 11
Przeglądaj online lub pobierz pdf Uwaga dotycząca konfiguracji dla Gateway AudioCodes GW & E-SBC Series. AudioCodes GW & E-SBC Series 20 stron.
Drukuj stronęConfiguration Note
2.2.2
MP-11x, Mediant 600, Mediant 1000, Mediant 2000, and Mediant
3000
For the MP-11x, Mediant 600, Mediant 1000, Mediant 2000, and Mediant 3000 devices,
follow the procedure below.
To restore factory defaults:
1.
At the CLI prompt, type the following command to access the configuration mode, and
then press the Enter key:
# conf
2.
At the prompt, type the following command to reset the device to default settings, and
then press the Enter key:
# RestoreFactorySettings
The CLI commands mentioned in the procedure are shown in the terminal emulation
program (HyperTerminal) below:
Figure 2-2: CLI for Resetting Device to Default (Non-MSBG Devices)
Version 6.4
2. Restoring Defaults using CLI
11
May 2012