Daniels 844.BLU.PLOW Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odśnieżarka Daniels 844.BLU.PLOW. Daniels 844.BLU.PLOW 16 stron. 3-in-1 plow

PLOW INSTALLATION

1. Connect the Daniels 3in1 Plow to the loader,

making sure the plow is securely locked in

place

2. Hydraulic hose installation

ports on the loader to the two empty ports on the

(Part #4) when routing the hoses. Make sure the

hoses will not be pinched when the plow is raised,

lowered, or hydro turned. Secure the two hoses

together with nylon zip ties as needed (Page 13,

appropriate length, raise the plow and roll the

hoses are not pulled or stretched during operation.

Operator's Manual

Check to be sure the 8" X 8" square tube (Throat Weldment) is

parallel to the pavement, as shown (Page 13, Diagram 2). When

be parallel to the pavement, create a visual reference point that

is visible from the loader cab by marking or painting a straight

line between the loader frame and the boom as shown (Page

13, Diagram 5). This will allow the operator to always return the

boom to the correct plowing position with the throat weldment

parallel to the pavement during use.

3-IN-1 PLOW

IMPORTANT!

For the easiest and safest shipping of

the Daniels 3in1 Plow the wings may

be bolted open. Check for and remove

this bolt prior to applying any hydraulic

pressure to the plow. The bolt is located

on the back side of the plow under both

wing cylinders. The bolt connects the

outer most rib of the center board section

of the 3in1 Plow to the inner most rib of

the wing section of the 3in1 Plow.