BrakeBuddy Select II Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt diagnostyczny BrakeBuddy Select II. BrakeBuddy Select II 8 stron. Portable braking system

Drukuj stronę
After attaching your towed vehicle to your coach and all hook-ups are complete, you will need to
attach the break-away cable from the junction box to the motorhome. DO NOT ATTACH OR WRAP
THE CABLE AROUND THE TOW BAR, HITCH OR BUMPER.
1.
Attach the small clip on the cable to the loop on the pull pin of the junction box, and then
attach the large clip to the motorhome. The coiled break-away cable fits all applications and
needs no adjustment.
2.
Install the BrakeBuddy® in your towed vehicle
3.
Before the start of every trip, pull the break-away pin to test that the break-away system
activates the BrakeBuddy®.
4.
When the use of the towed vehicle is needed, simply unhook the small clip from the loop on
the pull pin of the junction box. Unplug the power cord from the BrakeBuddy® and the dash
mount. Store power cord with BrakeBuddy®.
1.
Lift lever on back of unit to pull handle
up into ready position.
2.
Insert "Grey" end of power cord into
front of unit.
3.
Attach the lock nut and clevis
assembly to the arm extension.
4
Place BrakeBuddy® in floor of drivers
side towed vehicle.
5.
Attach clevis to brake pedal.
6.
Move BrakeBuddy® forward until the
arm extension is fully retracted. Make sure the
vehicle's brake pedal is not being pressed.
7.
Adjust the drivers seat forward until it is less
than a quarter inch away from the BrakeBuddy®
handle. Again, make sure the vehicles brake
pedal is not being pressed.
8.
Plug in "Black" end of the power cord into Dash
Mount Connector.
9.
With vehicle's engine OFF, push the red
Auto Start Button located on top of the
BrakeBuddy®. The arm will automatically extend
/ cycle 5 times. This will remove any vacuum
stored in the brake vacuum reservoir of the
towed vehicle as well as diagnose any errors in
the system startup.
Hopkins Manufacturing Corporation
USING THE BREAK-AWAY SYSTEM
SET UP
BrakeBuddy.com
Step 1.
Lever to raise handle
READY POSITION
This is how the unit should look prior
to placing in floor of towed vehicle
Step 2.
Insert power cord
1-800-470-2287