BrakeBuddy Select II Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt diagnostyczny BrakeBuddy Select II. BrakeBuddy Select II 8 stron. Portable braking system

Drukuj stronę

The BrakeBuddy® Remote provides 2-way communication

from the motorhome to the towed vehicle and provides

visual indications of problems that are occurring. (Fig. 3)

F - Main Unit Error (red light will activate) Stop and check

the main unit diagnostics for error.

G - Battery Low on Remote (replace with new AA battery)

H - Breakaway Warning (red light and audible signal will

activate) Stop Immediately!

I - On / Off Switch

NOTE: When the BrakeBuddy® system and motorhome

are not in use, turn the remote on / off switch to the

OFF position to conserve remote battery life.

A 12-volt DC power cord is also included. This bypasses

the on/off switch, and battery removal when using the

12-volt DC cord is not required.

NOTE: When done towing and parked, we recommend

you unplug the BrakeBuddy® system from the towed

vehicle 12-volt receptacle. If that is undesirable,

recharge the towed vehicle battery once every 3 days

to maintain optimum battery condition.

REMOTE SYNCHRONIZE PROCEDURE:

This device works similarly to a universal garage door

opener. If this remote ever becomes un-synced with the

main unit, simply perform the following procedure:

Power up / turn on both devices

(dinghy and remote).

On the BrakeBuddy® unit, hold down the (+) and ( _ )

buttons (A) simultaneously until the Air Pressure

setting reads "LL" (Fig. 4 / E).

Next, with the remote, hold down the Braking

Mode (C) and Braking Sensitivity (D) buttons

simultaneously for 5 seconds.

NOTE: User has 5 seconds to synchronize the remote

once "LL" is displayed.

Once the dinghy has completed the "link-up"

routine, the air pressure display will change from

"LL" to the last air pressure setting (# between 10

and 75).

Both the dinghy and coach units should be

displaying the same sensitivity setting and

sensitivity button presses on either unit should

cause both units to update to the new setting.

Hopkins Manufacturing Corporation

REMOTE OPERATION INSTRUCTIONS

BrakeBuddy.com

FIG. 3

FIG. 4

1-800-470-2287