AudioMX HG-31B Podręcznik użytkownika - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Słuchawki AudioMX HG-31B. AudioMX HG-31B 10 stron. Digital over-ear headphones

Notes:
1. For power saving and transmitter protection, the transmitter will automatically switch
to standby mode if there is no audio signal source for approximately 5 minutes (LED on
the transmitter will change to blue). If the audio source signal returns, the transmitter will
automatically switch on (LED on the transmitter will change to orange). Then, power on the
headphones again to listen to music.
2. The headphones will automatically switch off if there is no signal from the transmitter for 5
minutes.
Charging the headphones battery
1. Turn off the headphones by pressing the power button before charging. This may avoid
battery damage.
2. Place the headphones on the top of the transmitter. Make sure the charging pins on the
transmitter and charging contacts of the headphones are matched.
3. The indicator on the transmitter will light in purple during charging process and change
to blue when charging is completed.
Notes:
1. To ensure a longer service life, fully charge the batteries for 7 hours before using the headphones
for the first time. According to the capacity of the rechargeable battery included, the battery
charging process will take approximately 5 hours.
2. Do not charge the batteries over 12 hours. Overcharging may lead to damage of batteries.
Cautions
1. Never attempt to recharge conventional dry cells (batteries).
2. Do no expose the batteries to excessive heat such as direct sunshine, fire or the like.
08
3. Store the transmitter and headphones in a dry and clean place. Humidity or dust may
cause damage to the inside components.
4. Never use another type of battery or non-rechargeable batteries to replace the
rechargeable batteries supplied.
5. Do not disassemble transmitter or the headphones on your own. It may cause damage.
6. Excessive sound pressure from headphones can cause hearing loss.
Trouble-shooting
Problem
No sound
Distortion
Possible Solution
Make sure the AC / DC adaptor is
fully inserted into the AC outlet and the
power connection input on the transmitter.
Make sure the headphones are switched on.
Headphones battery charging level
maybe too low. Recharge the batteries fully.
Make sure the TV or the connected
audio device is switched On.
The volume of the headphone may be too
low. Adjust the volume to a moderate level.
The audio signal input level is too
Increase the volume of the audio source.
Ensure the volume level of the
headphones is set to an appropriate level.
09