aevit 2.0 Instrukcja instalacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Uchwyt TV aevit 2.0. aevit 2.0 17 stron. Mounting brackets
Drukuj stronę2. prIMArY INpUT
2.1 gENErAL INFOrMATION
The primary input section will describe how to install the mount-
ing brackets for the Primary Inputs which include: Digital Lever,
Wheel, and single and dual axis joysticks. As the name states, these
devices perform the tasks of operating the primary functions of the
vehicle: Steering and Gas/Braking. Generally, the Gas/Brake controls
are installed on the left hand side of the driver and utilize the door
mounting bracket system and the steering controls are installed
on the right hand side of the driver and utilize the floor mounting
bracket system. however, only the base plate of each mounting
system is different (See figure to the right for mounting system com-
ponents). Sections 2.2 and 2.3 will go into detail about installing the
bases of the Floor and Door mounting systems and section 2.4 will
discuss the generic adjustment section installation. Finally, section
2.5 will discuss other mounting options.
ThESE INSTRUCTIONS ShOULD BE READ ThOROUGhLy BEFORE ATTEMPTING TO INSTALL ThIS
EqUIPMENT. FAILURE TO DO SO COULD CAUSE ThESE MOUNTING BRACKETS TO BE INSTALLED
INCORRECTLy LEADING TO AN ACCIDENT RESULTING IN SERIOUS INjURy AND/OR DEATh.
•
INSTALL ThE EMC MOUNTING BRACKETS IF ALL COMPONENTS ARE NOT PROVIDED IN ThE KITS.
•
DEVIATE FROM ANy STEPS ShOWN IN ThESE INSTRUCTIONS UNLESS APPROPRIATE. (I.E. "OThER MOUNTING
OPTIONS" SECTION).
•
INSTALL ThIS EqUIPMENT IF yOU ARE UNSURE ABOUT ANy STEP IN ThESE INSTRUCTIONS.
2.2 MOUNTINg BASE INSTALLATION - FLOOr
Before installing the Floor Mounting system, verify that the following components are included with the BRKT-AEVIT-
FLR mounting kit:
(1) Floor Base Plate
(1) Input Device Articulating Swivel Brkt
(1) Input Device Mounting Ball
(1) Mounting Ball hardware Kit
IF ANy OF ThESE COMPONENTS ARE NOT INCLUDED WITh ThE BRKT-AEVIT-FLR, CALL ThE EMC
SERVICE DEPARTMENT. dO NOT ATTEMpT TO INSTALL wIThOUT ALL pArTS.
WARNING:
cAuTION:
wHAT NOT TO DO
(4) 3/8" x 2" hex head Bolts
(8) 3/8" Flat Washers
(4) 3/8" Lock Nuts
NOTE:
Mounting Brackets
FIGuRE 3
(BrkT-AEVIT-FLr)
AEVIT 2.0 MOUNTING BRACKETS INSTALL MANUAL
2-1
INPuT DEvIcEs
ADjusTMENT
SECTION
FLOOR BASE
PlATE