aevit 2.0 Instrukcja instalacji - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Uchwyt TV aevit 2.0. aevit 2.0 17 stron. Mounting brackets
Drukuj stronęprIMArY INpUT
2.2 MOUNTINg BASE INSTALLATION - FLOOr
(CONTINUEd)
sTEP 1
Determine the location for the Floor Base Plate. This will change depending on the needs of the client. EMC recom-
mends that it be mounted between the two front seats with the webbing facing towards the passenger seat and the
AEVIT 2.0 Chassis be mounted partially on top of it as shown in the figures below (See your vehicle specific AEVIT 2.0
Installation Manual for information on mounting the AEVIT 2.0 Chassis). The Floor Base Plate and the AEVIT 2.0 Chassis
should also be mounted as far forward in the vehicle as possible. This will reduce the overall footprint of the system
and allow the client to move their wheelchair in and out of the driver's area more effectively. It is also very important
to make sure that the Floor Base Plate does not extend to the left into the drivers area as this will interfere with the cli-
ent's wheelchair movements.
Mount the
floor Base
plate with
the weBBing
towards the
passenger's
seat
sTEP 2
Once the location of the mounting bracket is selected, drill (4) 3/8"
holes through the floor.
BEFORE DRILLING IN ThE OEM VEhICLE, ChECK ALL AREAS ABOVE AND BELOW
TO AVOID DRILLING ThROUGh WIRE hARNESSES OR OThER EqUIPMENT.
sTEP 3
Mount the Floor Base Plate to the floor of the vehicle using (4) 3/8" x 2" hex head bolts, (8) 3/8" flat washers, and (4)
Lock nuts. Once the Base Plate is mounted, skip to section 2.4 for the adjustment and input device installation infor-
mation.
WhEN MOUNTING ThE AEVIT 2.0 ChASSIS IN ThIS CONFIGURATION, yOU WILL NEED TO
PROVIDE FOUR (4) SPACERS WhICh ARE AT LEAST 1/2" ThICK TO RAISE ThE ChASSIS OVER
ThE FLOOR BASE PLATE AND ITS MOUNTING BOLTS. ThESE SPACERS ARE ShOWN IN
Mount the
aevit 2.0
chassis
over the
floor Base
plate
wEBBINg
FIGuRE 4A
WARNING:
verify that
the floor
Base plate
does not
extend into
the driver's
area
FIGuRE 4b
NOTE:
FIGURE 4B.
AEVIT 2.0 MOUNTING BRACKETS INSTALL MANUAL
(BrkT-AEVIT-FLr)
SpACErS
2-2