aevit VIC 2.0 Instrukcja instalacji i obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Jednostka sterująca aevit VIC 2.0. aevit VIC 2.0 17 stron. Voice interactive controls
Drukuj stronę4. TrAININg
4.1 IMpOrTANT CrITerIA FOr TrAININg
EMC recommends that the Certified Technician complete the entire training process so they are famil-
iar with training VIC 2.0. This will speed up time spent with training the client.
This section assumes that the AEVIT 2.0 system has been properly installed, is functioning properly
and the initial bootup procedure has been completed. See the Operation and Programming Manual
for more information.
VIC 2.0 has two parts to the training. Part 1, Training, is to record and train the words and Part 2, rec-
ognition, is to test the recognition of the words trained during Part 1.
In order to begin training you MUST have:
•
All vehicle doors & windows shut
•
AEVIT 2.0 system awake
•
Vehicle's ignition OFF
•
Everything as
The AEVIT 2.0 system will stay awake for 30 minutes when the vehicle's ignition is not on but the system is
awake. The entire training processes takes approximately 15 minutes so there is plenty enough time to com-
plete the training before AEVIT 2.0 automatically goes to sleep. The more quiet the environment is, the more
success you will have training VIC 2.0.
During the training of VIC 2.0 it is important to:
•
Make sure the microphone is positioned correctly. The WHITE dot on the microphone should be
pointed toward the client as shown in the figures below.
•
Speak loudly and clearly
•
During Part 2,
in Part 1, Training.
•
Wait for the "beep".
For best training and recognition results, wait approximately (1) second after the "beep" to be-
gin speaking.
QUIeT as possible
CORRECT
WHITE DOT SHOULD
POINT TOWARDS CLIENT
recognition, repeat the command as close as possible to the way it was trained
VIC 2.0 will inform you when it time to speak by playing an audible "beep".
INCORRECT
VIC 2.0
4-1
VIC 2.0 INSTALL MANUAL